Installing an 850 W Internal AC Power Supply

The Summit X650 series switch is shipped without installed power supplies.

The switch accommodates one or two Summit 850 W power supply units.

Caution

Make sure that the AC power supply circuit is not overloaded. Use proper overcurrent protection, such as a circuit breaker, to prevent overcurrent conditions.

To install an 850 W AC power supply in a Summit X650 series switch, follow these steps:

Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate grounding point.
If necessary, remove a blank panel from the back of the Summit X650 series switch.

Removing a Blank Panel
Verify that the power supply is right side up, with the latching tab at the right of the unit (see Installing a Power Supply).
Carefully slide the power supply all the way into the power supply bay (see Installing a Power Supply).
Push the power supply in until the latch snaps into place.

Caution

Do not slam the power supply into the switch.

Installing a Power Supply
To install a second power supply, repeat the procedure.

Note

If power supplies are not installed in both power supply bays, be sure to install a cover over the unoccupied bay. Unoccupied bays must always be covered to maintain proper system ventilation and EMI levels.
Connect an appropriate AC power cord to the power input socket; connect the other end of the power cord to a grounded AC power outlet.

Warning

Always be sure that the source outlet is properly grounded before plugging the AC power cord into the unit.