Refer to Installing an LRM/MACsec Adapter for installation options for the LRM/MACsec Adapter.

Note
The LRM/MACsec Adapter is
hot-swappable.
To replace an LRM/MACsec Adapter or remove it from service, follow these steps:
-
If a USB cable is used to supply
power to the adapter, unplug the USB cable from the front of the adapter.
-
Disconnect network cables or
transceivers from the Link1 and Link2 slots on the front of the adapter.
-
Disconnect the 50 cm SFP cables
from the HostPort1 and HostPort2 slots on the front of the adapter.
-
Carefully holding the adapter,
loosen and remove the screws that secure the adapter to the rack posts or to the
five-slot bracket.
-
Remove the adapter.
-
Install a new adapter using any
of the installation options listed in Installing an LRM/MACsec Adapter.
-
Connect the new adapter to the
switch and to power, following the instructions in Connecting the LRM/MACsec Adapter to the Host Switch and to Power.

Caution
Connect the adapter to the host switch using only the SFP cable that is
provided for this purpose. The use of other cables can damage the
equipment.
-
Reconnect network cables and
transceivers to the Link1 and Link2 slots on the front of the new adapter.