Installing an 850 W Internal DC Power Supply

The Summit X650 series switch is shipped without installed power supplies.

The switch accommodates one or two Summit 850 W power supply units.

Caution

Caution

Make sure that the DC power supply circuit is not overloaded. Use proper overcurrent protection, such as a circuit breaker, to prevent overcurrent conditions. You may use up to a 30 Amp breaker.

To install the 850 W DC power supply, perform the following tasks in the order listed:

  1. Make sure you have the tools and materials you need.

    See Required Tools and Materials for Installing an 850 W DC Power Supply.

  2. Prepare the power cables and ground cable by attaching the provided connection lugs to the cables.

    See Preparing the Cables for an 850 W DC Power Supply.

  3. Insert the power supply into the switch.

    See Installing an 850 W DC Power Supply.

  4. Connect the ground wire.

    See Connecting the Ground Wire to an 850 W DC Power Supply.

  5. Connect the power supply to the DC source voltage.

    See Connecting an 850 W DC Power Supply to the DC Source Voltage.

  6. Energize the DC circuit.
121141-04 Rev. AB