Install a V300 Virtual Port Extender in a VESA Mount

The following tools and materials are required to install a V300 Virtual Port Extender with a VESA mount:

  • ESD-preventive wrist strap
  • M4 #2 Phillips screwdriver (magnetic screwdriver recommended)

The VESA mount comes with 4 screws and should be used when mounting the V300 Virtual Port Extender to a VESA mount for 75mm x 75mm or 35mm x 75mm mounting dimensions. To install a V300 Virtual Port Extender in a VESA Mount:

  1. Attach the VESA mount to the underside of the port extender using four screws (included):
    Click to expand in new window
    VESA Mounting
  2. For non-PoE models, after attaching the PSU bracket to the V300, attach the PSU(s) to the PSU mounting brackets using two cable ties:
    Click to expand in new window
    V300-8P/8T-2X VESA Mounting with PSU
    V300-8P-2X VESA mounting top view with VESA protruding from the wall, PSU attached to the rear, with cable ties around PSU
    V300-8T-2X VESA mounting top view with VESA protruding from the wall, PSU attached to the rear, with cable ties around PSU
  3. Connect the LAN/Ethernet cables to the extender.
  4. When power is connected, verify that the SYS LED on the port extender turns green.
121141-04 Rev. AB