Installing the EPS-150DC Power Supply

Note

Note

Install the EPS-T2 before you begin installing the EPS-150DC.
Warning

Warning

Always be sure that the DC circuit is de-energized before connecting or disconnecting the DC wiring harness at the DC power socket on the rear of the EPS-150DC unit, and before connecting or disconnecting the redundant power cord between the switch and the EPS-150DC unit.

To install an EPS-150DC unit, perform the following tasks in order:

  1. Connecting the DC Wiring Harness to the DC Source Voltage

    This task must be performed by a licensed, qualified electrician.

  2. Installing an EPS-150DC Unit into an EPS-T2
  3. Connecting the DC Wiring Harness to the DC Power Socket on the EPS-150DC
  4. Connecting the EPS-150DC to a Switch
121141-04 Rev. AB