Summit X430-8p Switch Ports and Slots

The front panel of the Summit X430-8p switch includes:

• Eight fixed autosensing 10/100/1000BASE-T ports (ports 1–8) that provide 8 Gbps of high-density copper connectivity. In addition, all of these ports (ports 1-8) also support the POE protocol IEEE802.af and POE+ protocol IEEE 802.at standard. Using the POE protocol, the switch can provide 15.4 Watts of power on a single port up to a total power budget of 60 Watts. Using the POE+ protocol, the switch can provide 30 Watts of power on a single port up to a total power budget of 60 Watts.
  

  Note

  Up to 90 watts of PoE power can be configured on the switch if it is used standalone and not in a rack.
• Two unpopulated 1000BASE-X SFP ports (ports 9–10) that provide 2 Gbps of fiber connectivity.
  

  Note

  All the eight 10/100/1000BASE-T ports and all of the 1000BASE-X SFP ports can be used simultaneously.

  For information about SFPs, see the Extreme Networks Pluggable Interface Modules Installation Guide.

• Ethernet management port.
• Serial console port implemented as an RJ45 connector, used to connect a terminal and perform local management.
• LEDs to indicate port status and switch operating conditions

  For a description of the LEDs and their operation, see Summit X430 Series Switch LEDs.

  

  Note

  If you are desktop mounting a Summit X430-8p switches you must use the four rubber pads to maintain sufficient airflow around the unit See Installing Summit Switches in Desktop or Free-Standing Mode for installation instructions.

  

  Note

  If you are rack mounting Summit X430-8p switches, you must use special "keep out" rack mounting hardware. Rack mounting hardware must be ordered separately and you must reserve at least 2 RU of space for the unit. For installation instructions, see Installing a Summit X430-8p or X440-8t Switch in a Rack.

Summit X430-8p Switch Front Panel

Summit X430-8p Switch Rear Panel