Install the Access Point on a Wall Using ACC-MBO-KT-AX Adapter and KT-147407-02 Bracket Parts

Learn how to install an outdoor access point using the ACC-MBO-KT-AX adapter with the KT-147407-02 bracket wall parts.

Before you begin

The following hardware is required for outdoor access point wall installation using the -MBO adapter and the KT-147407-02 bracket parts:
  • One outdoor access point
  • One ACC-MBO-KT-AX adapter
  • Four M5 hex bolts
  • Flat part of the KT-147407-02 bracket
  • 1-axis tilt part of the KT-147407-02 bracket
  • Four M6 hex screws with split washer and hex nut
  • Four M6 headsize screws
  • Four M6 screws
Note

Note

All accessories must be purchased separately.

About this task

The ACC-MBO-KT-AX adapter is used with outdoor access points to add a tilt to the access point after installation. For wall installations, the -MBO adapter is used in combination with the KT-147407-02 bracket wall parts. The KT-47407-02 has three bracket parts, two parts for wall installation and one part for pole installation.

For pole installations, the ACC-MBO-KT-AX adapter is used in combination with the KT-147407-02 bracket wall and pole parts.
Click to expand in new window
ACC-MBO-KT-AX adapter bracket for outdoor access point tilt
Metal square bracket with screws and bolts
Click to expand in new window
KT-147407-02 bracket flat part front view
Metal box bracket straight-on view displaying four semi-circular cuts on each edge.
Click to expand in new window
KT-147407-02 bracket flat part side view
Metal box bracket side view displaying four semi-circular cuts on each edge.
Click to expand in new window
KT-147407-02 bracket 1-axis tilt part front view
Metal bracket with four semi-circular cuts on each corner.
Click to expand in new window
KT-147407-02 bracket 1-axis tilt part side view
Side view of the metal bracket displaying four semi-circular cuts on each corner.

Procedure

  1. Attach the ACC-MBO-KT-AX adapter to the access point using four M5 bolts.
    Click to expand in new window
    ACC-MBO-KT-AX adapter bracket attachment to an outdoor access point
    Metal bracket being attached to the back of an outdoor access point using screws and bolts.
  2. Torque the M5 bolts to 25 in-lbs.
  3. Attach the flat part of the KT-147402-02 bracket to the ACC-MBO-KT-AX adapter using four M6 screws, split washers, and hex nuts.
    Click to expand in new window
    KT-147407-02 flat part attachment to -AX adapter bracket
    Flat metal bracket being attached to the back of the -AX adapter on an outdoor access point.
  4. Torque the bolts to 45 in-lbs.
  5. Using the 1-axis tilt bracket as a template, mark and drill four holes on a wall or on a flat surface.
  6. Attach the 1-axis tilt bracket to a wall or a flat surface using four M6 headsize screws.
  7. Align the 1-axis tilt bracket part inside the flat part of the KT-147407-02 bracket, and attach the flat bracket to the 1-axis tilt bracket using four M6 screws.
  8. Tilt the access point to a desired angle and tighten the four M6 screws to a torque of 45 in-lbs.
    The tilt bracket has +15 degrees to -15 degrees of tilt.