Install the AP305C/CX Access Point on a 15/16 in. Wide Ceiling Rail Using ACC-BKT-TB-NF Adapter

About this task

The AP305C/CX access point can be mounted on a 15/16 in. wide ceiling rail using the ACC-BKT-TB-NF adapter, when the ceiling tile protrudes below the T-bar. The AP305C/CX access point comes with in-built clips in the back of the access point that attach directly on to the -NF adapter, eliminating the need for the -TB accessory.

Procedure

  1. Remove the ceiling tiles.
  2. Using the adapter guide on the top half of the ACC-BKT-TB-NF adapter, align and attach the -NF on to the ceiling rail.
    Click to expand in new window
    ACC-BKT-TB-NF adapter
    ACC-BKT-TB-NF adapter with side protrusion
    Callout Description
    1 Adapter guide for ceiling rail attachment
    2 Adapter end
    3 Indent for - NF second part attachment
    4 Adapter tabs
  3. Slide the other part of the -NF adapter onto the half attached to the ceiling rail.
    Note

    Note

    When the adapter parts are attached properly, the adapter ends will line up after the two halves have snapped together.
  4. Align the built-in clips on the AP305C/CX access point against the -NF adapter end.
  5. Rotate the access point clockwise and attach it to the -NF adapter until it clicks into place.
  6. Plug the RJ45 connector plug into ETH or ETH0, RJ45 connector receptacle on the access point.
  7. Attach the Ethernet port cap to the access point Ethernet port.
    For more information about Ethernet cap, refer to Ethernet Cap Accessory Information.
  8. Place the cable cover over the Ethernet cable.
  9. Replace the ceiling tiles.