Install the Access Point on a Pole Using ACC-MBO-KT-AX Adapter and KT-147407-02 Bracket Parts

Learn how to install an outdoor access point on a pole using the -MBO adapter with the KT-147407-02 bracket parts.

Before you begin

The following hardware is required for outdoor access point pole installation using the -MBO adapter and KT-147407-02 bracket parts:
  • One outdoor access point
  • One ACC-MBO-KT-AX adapter
  • Four M5 hex bolts
  • Flat part of the KT-147407-02 bracket
  • 1-axis tilt part of the KT-147407-02 bracket
  • Pole part of the KT-147407-02 bracket
  • Four M6 screws with split washers and nuts
  • Four M6 screws
  • Two hex-head M12 stainless-steel bolts
  • Two hex-head M12 stainless-steel nuts
  • Two 0.5 in. wide stainless-steel cable clamps for pole mounting

About this task

The ACC-MBO-KT-AX adapter is used with outdoor access points to add a tilt to the access point after installation. For pole installations, the -MBO adapter is used in combination with all three KT-147407-02 bracket parts.
Note

Note

The cable glands must face down when you install the access point on a pole.
Click to expand in new window
KT-147407-02 bracket pole part front view
Metal square bracket with four handles on each corner displaying semi-circular cuts.
Click to expand in new window
KT-147407-02 bracket pole part side view
Metal square box bracket with step-like ridges on opposite sides for pole installation.

Procedure

  1. Attach the ACC-MBO-KT-AX adapter to the access point using four M5 bolts.
  2. Torque the M5 bolts to 25 in-lbs.
  3. Attach the flat part of the KT-147402-02 bracket to the ACC-MBO-KT-AX adapter using four M6 screws, split washers, and hex nuts.
  4. Torque the bolts and nuts to 32 in-lbs.
  5. Align the 1-axis tilt bracket part inside the flat part of the KT-147407-02 bracket, and attach the flat bracket to the 1-axis tilt bracket using four M6 screws.
  6. Adjust the tilt and tighten the screws to a torque of 32 in-lbs.
  7. Attach the KT-147407-02 pole part to the 1-axis tilt part using two M12 bolts through the large bracket holes on 1-axist tilt part and the pole part.
  8. Fasten the bolts using two M12 hex nuts and torque it to 22 ft-lbs..
  9. Insert the 0.5 in. stainless-steel cable clamp through the large slots on the pole bracket.
  10. Position the cable clamps on the bracket around a pole.
  11. Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 14 in-lbs.