Install the Access Point on a Pole Using ACC-MBO-KT-AX Adapter, KT-147407-02 Bracket Parts, and KT-150173-01 Extension Arm

Learn how to install an outdoor access point on a pole using the -MBO adapter with KT-147407-02 bracket parts and the KT-150173-01 extension arm.

Before you begin

The following hardware is required for outdoor access point pole installation using the -MBO adapter, KT-147407-02 bracket parts, and KT-150173-01 extension arm:
  • One outdoor access point
  • One ACC-MBO-KT-AX adapter
  • Four M5 hex bolts
  • Flat part of the KT-147407-02 bracket
  • 1-axis tilt part of the KT-147407-02 bracket
  • Pole part of the KT-147407-02 bracket
  • One KT-150173-01 extension arm
  • Six M6 screws
  • Four hex-head M12 stainless-steel bolts
  • Four hex-head M12 stainless-steel nuts
  • Two 0.5 in. wide stainless-steel cable clamps for pole mounting

About this task

Use the -MBO adapter in combination with the KT-147407-02 bracket parts and the KT-150173-01 extension arm for pole installations.
Note

Note

The cable glands must face down when you install the access point on a pole.

Procedure

  1. Attach the ACC-MBO-KT-AX adapter to the access point using four M5 bolts.
  2. Tighten the bolts to a torque of 25 in-lbs.
  3. Attach the KT-147407-02 flat part and the 1-axis tilt part.
    For instructions on how to attach the bracket parts, see Steps 2 and 3 in the Install the Access Point on a Wall Using ACC-MBO-KT-AX Adapter, KT-147407-02 Bracket Wall Parts, and KT-150173-01 Extension Arm procedure.
  4. Tighten the screws and nuts to a torque of 32 in-lbs.
  5. Align the circular holes on one end of the KT-150173-01 extension arm against the large holes on the 1-axis tilt bracket part.
  6. Attach the KT-150173-01 extension arm to the 1-axis tilt bracket using two hex-head M12 stainless-steel screws and two hex-head M12 stainless-steel nuts.
  7. Attach the KT-147407-02 pole part to the other end of the KT-150173-01 extension arm using two M12 screws and M12 hex-nuts.
  8. Tighten the M12 bolts and nuts to a torque of 22 ft-lbs.
  9. Insert 0.5 in. stainless-steel cable clamps through the KT-147407-02 pole part long slots.
  10. Position the cable clamps around a pole.
  11. Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 14 in-lbs.