Install the Access Point on a Wall or a Solid Ceiling Using AH-ACC-BKT-AX-TB Accessory

Before you begin

The following hardware is required for installing the AH-ACC-BKT-AX-TB accessory on a wall or a solid ceiling:
  • An indoor access point
  • One AH-ACC-BKT-AX-TB Accessory
  • Two M3.5 pan head wood screws
  • Two screw-in anchors
Note

Note

The wood screws and screw-in anchors come in a separate plastic bag.

About this task

You can use the AH-ACC-BKT-AX-TB accessory for flat surface wall or solid ceiling installation.

Procedure

  1. Using the AH-ACC-BKT-AX-TB accessory as a template, mark and drill two mounting holes.
  2. Attach the accessory to the wall using the M3.5 pan head wood screws.
    Use push-in anchors or screw-in anchors for drywall or plastic board installations on vertical walls.
    Note

    Note

    Screw-in anchors must be used for ceiling installations.
  3. Attach the access point to the accessory by aligning the red dot on the accessory and the access point.
  4. Press and rotate the access point 1/8th turn clockwise until it clicks into place on the accessory.
  5. Attach the Cat5e RJ45 cable to the ETH0 port on AP305C/CX or the Cat6 RJ45 cable to the ETH0 or ETH1 port on all other indoor access points.
  6. Place the cable cover over the Ethernet cable.