Install the Access Point on a Wall Using ACC-MBO-KT-AX Adapter, KT-147407-02 Bracket Wall Parts, and KT-150173-01 Extension Arm

Learn how to install an outdoor access point on a wall using ACC-MBO-KT-AX adapter, KT-147407-02 bracket wall parts, and KT-150173-01 extension arm.

Before you begin

The following hardware is required for outdoor access point wall installation using the -MBO adapter, KT-147407-02 bracket parts, and the KT-150173-01 extension arm:
  • One outdoor access point
  • One ACC-MBO-KT-AX adapter
  • Four M5 hex bolts
  • Flat part of the KT-147407-02 bracket
  • 1-axis tilt part of the KT-147407-02 bracket
  • Four M6 hex screws with split washer and hex nut
  • Four M6 head size screws
  • Four M6 screws
  • One KT-150173-01 extension arm
  • Two hex-head M12 stainless-steel screws and nuts
  • Four M6 hex-head screws and optional screw-in anchors

About this task

The ACC-MBO-KT-AX adapter is used with outdoor access points to add a tilt to the access point after installation. For wall installations, the -MBO adapter is used in combination with the KT-147407-02 bracket wall parts. To add extension to your wall installations, use the KT-150173-01 extension arm in combination with the KT-47407-02 bracket parts.
Click to expand in new window
KT-150173-01 extension arm
Long extension arm with flat plates on each end.

Procedure

  1. Attach the ACC-MBO-KT-AX adapter to the access point using four M5 bolts.
  2. Torque the M5 bolts to 25 in-lbs.
  3. Attach the flat part of the KT-147402-02 bracket to the ACC-MBO-KT-AX adapter using four M6 hex screws, split washers, and hex nuts.
  4. Torque the M6 screws and nuts to 45 in-lbs.
  5. Align the 1-axis tilt bracket part inside the flat part of the KT-147407-02 bracket, and attach the flat bracket to the 1-axis tilt bracket using four M6 screws.
  6. Set the desired angle on the tilt bracket and tighten the screws to a torque of 45 in-lbs.
  7. Using the KT-150173-01 extension arm as a template, mark and drill four hole centers on a flat surface.
    The holes must be within the circular cuts in the end of the flange.
  8. Attach one end of the KT-150173-01 extension arm to the 1-axis tilt bracket using two hex-head M12 stainless-steel screws and two hex-head M12 stainless-steel nuts through the two large circular holes on the KT-150173- 01 extension arm.
  9. Torque the M12 bolts and nuts to 22 ft-lbs.
  10. Attach the KT-150173-01 extension arm, that now has the access point mounted on the other end, to a flat surface using four M6 size hex-head screws.
    Use screw-in anchors with the four M6 hex-head screws when you mount the bracket on a wood surface and use concrete anchors for concrete surface.