Configuring the Agent IP Address

Use this procedure to configure the source of the Application Telemetry packets.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enable the agent IPv4 address:

    sflow agent–ip {A.B.C.D}

Example

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Switch:1(config)#sflow agent-ip 192.0.2.27

Variable Definitions

Use the data in the following table to use the sflow agent-ip command.

Variable

Definition

{A.B.C.D.}

Specifies the agent-ip address (IPv4).
9037347-00 Rev AD