View DvR Interfaces

About this task

View the DvR interfaces on either a Controller or a Leaf node.

On Controllers, DvR interfaces are created when you configure IP on a DvR enabled Layer 2 VSN (VLAN, I-SID). Only Controllers display the administrative state of the interfaces because this is where you enable or disable the interfaces. On a Leaf node, the DvR interface information that the Controllers push, for example, subnet routes and the gateway IP addresses for the Layer 2 VSNs, are displayed.

Before you begin

Ensure that you enable DvR globally on the node.

Procedure

  1. In the navigation pane, expand the Configuration > Fabric folders.
  2. Click DVR.
  3. Click the Interfaces tab.

    Click Filter to filter rows based on specific filter criteria.

Interfaces field descriptions

Use the data in the following table to use the Interfaces tab.

Name

Description

VlanIpAddrType

Specifies the VLAN IP address type of the DvR interface.

VlanIpAddr

Specifies the VLAN IP address (IPv4) of the DvR interface.

L3Isid

Specifies the Layer 3 I-SID of the DvR interface.

The range is 1 to 16777215.

L2Isid

Specifies the Layer 2 I-SID of the DvR interface.

The range is 1 to 16777215.

VlanIpMask

Specifies the VLAN IP address mask of the DvR interface.

VrfId

Specifies the VRF ID of the DvR interface.

The VRF ID is 0 for the GRT.

VlanId

Specifies the VLAN ID of the DvR interface.

GwIpAddrType

Specifies the address type of the DvR gateway IP address (IPv4).

GwIpAddr

Specifies the DvR gateway IP address (IPv4).

AdminState

Specifies the administrative state of the DvR interface.

SpbmcState

Specifies the state of IP Multicast over Fabric Connect, on the DvR interface.

IgmpVersion

Specifies the version of IGMP that runs on the DvR interface.