Configure Link Debounce

About this task

Configure Link Debounce for ports to hold the connection path until the carrier side switchover is complete.

Procedure

Enter GigabitEthernet Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Enable Link Debounce:

link-debounce <0-300000>
Verify the configuration:

show interfaces gigabitEthernet link-debounce [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Examples

Configure the Link Debounce timer on port 1/2 to 300000 milliseconds.

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#interface gigabitEthernet 1/2
Switch:1(config-if)#link-debounce 300000

Display the Link Debounce configuration for ports 1/1 through 1/4.

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#show interfaces gigabitEthernet link-debounce 1/1-1/4
================================================================================
                               Port link debounce
================================================================================
--------------------------------------------------------------------------------
PORT     LINK-DEBOUNCE     LINK-DEBOUNCE         DEBOUNCE    DEBOUNCE
NUM      STATUS            TIMER MILLISECONDS    COUNT       SUCCEEDED
--------------------------------------------------------------------------------
1/1      Enable            1500                   0           0
1/2      Enable            300000                  0           0
1/3      Disable           --                     0           0
1/4      Enable            4000                   0           0