Configure Ports Speeds for All VIM Ports

Note

This procedure only applies to 5520 Series.

Configure all of the ports on an installed Versatile Interface Module (VIM) to operate at the same speed.

Note

Some VIMs must operate with all ports at the same speed, while others can operate with ports at different speeds. For more information, see Fabric Engine Release Notes. You can configure VIM ports speed only on VIMs that must operate with all ports at the same speed.

Before you begin

Install the VIM before performing this procedure.

About this task

Use this procedure to configure the speed of all ports in a multi-port VIM to operate at either 10 Gbps or 25 Gbps.

Procedure

In the navigation pane, expand Configuration > Edit.
Select Chassis.
Select the VIM tab.
Select mbps10000 or mbps25000.
Select Apply.

VIM Field Descriptions

Use the data in the following table to use the VIM tab.


Name	Description
AdminSpeed	mbps10000: Configures all ports in a multi-port VIM to operate at 10 Gbps. mbps25000: Configures all ports in a multi-port VIM to operate at 25 Gbps. The default is 25 Gbps.