Configure an IPv6 Address for a Segmented Management Instance

Use this task to configure or view IPv6 address information for a Segmented Management Instance.

Before you begin

  • Ensure the IP address you plan to assign is not in use by an existing VLAN or CLIP IP subnet configured on the switch.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Select Mgmt Instance.
  3. Select Mgmt.
  4. Select the Ipv6Address tab.
  5. Select Insert.
  6. Select the Segmented Management Instance interface type.
  7. Type the address information.
  8. Select Insert.

Ipv6Address Field Descriptions

Use the data in the following table to use the Ipv6Address tab.

Name

Description

InstanceId

Specifies the interface instance.

Address

Specifies the IPv6 address for the interface instance.

Ensure that the management CLIP IP address does not fall into the range of a configured VLAN IP address range as this is not allowed.

PrefixLength

Specifies the prefix length for the IPv6 address.

AddrOrigin

Shows the IPv6 address origin.

IntfName

Shows the interface name.

DadStatus

Shows the IPv6 DAD status of the address.
9037347-00 Rev AD