Disable Auto-sense DHCP Server Detection

About this task

Perform this procedure to disable Dynamic Host configuration Protocol (DHCP) server detection in Auto-sense mode.

Note

By default Auto-sense DHCP server detection is enabled. This ensures automatic detection of the DHCP uplink ports in Zero Touch Deployment.

1. Enter Global Configuration mode:

   enable

   configure terminal

2. Disable DHCP server detection:

   no auto-sense dhcp-detection

Example

Enable DHCP server detection:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#no auto-sense dhcp-detection