Clear IPv6 Statistics

Clear all IPv6 statistics if you do not require previous statistics.

Procedure

Enter Privileged EXEC mode:

enable
Clear all the IPv6 statistics:

clear ipv6 statistics all [vrf WORD<1–16> | vrfids WORD<0–512>]
Clear interface statistics:

clear ipv6 statistics interface [general|icmp] [gigabitethernet {slot/port[/sub-port]}>| loopback <1–256> | tunnel <1-2000> | vlan <1-4059>] [vrf WORD<1–16> | vrfids WORD<0–512>]
Clear TCP statistics:

clear ipv6 statistics tcp [vrf WORD<1–16> | vrfids WORD<0–512>]
Enter the following command to clear UDP statistics:

clear ipv6 statistics udp [vrf WORD<1–16> | vrfids WORD<0–512>]

Use the information in the following table to use the clear ipv6 statistics commands.


Variable	Value
gigabitethernet `{slot/port[/sub-port]}`	Identifies a single slot and port. If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
loopback <1–256>>	Identifies a loopback interface.
tunnel `<1-2000>`	Identifies a 6in4 tunnel ID.
vlan`<1-4059>`	Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
vrf `WORD<1–16>`	Specifies the VRF name.
vrfids `WORD<0–512>`	Specifies the VRF ID.