Configure a Auto-sense Global Data I-SID

Before you begin

Enable Auto-sense on the port.
Associate a VLAN with the I-SID before you configure it as the global data I-SID.

About this task

Perform this task to configure Auto-sense data traffic information for ports that are operating in Auto-sense mode.

Note

This option applies to the auto-sense UNI and voice states only, it replaces the onboarding I-SID and places an (untagged) client device into a pre-defined global data I-SID.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure the data service instance identifier (I-SID):

auto-sense data i-sid <1-15999999>

Example

Configuring the Auto-sense data I-SID:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#auto-sense data i-sid 1000

Variable Definitions

The following table defines parameters for the auto-sense data command.


Variable	Value
i-sid `<1-15999999>`	Specifies the service instance identifier (I-SID).