Associate an I-SID with an ACL

Before you begin

  • The inVsn ACL exists.

  • This I-SID is already configured on the fabric node.

About this task

For inVsn ACL types, specify the I-SID associated with the customer VLAN (Layer 2 VSN), the customer VRF (Layer 3 VSN), or the IP Shortcut.

Note

Note

For IP Shortcut traffic, the inVsn ACL match type must be both. In this case, the I-SID is zero (0).

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Specify the I-SID.

    filter acl i-sid <acl-id> <0–15999999>

Variable definitions

Use the data in the following table to use the filter acl i-sid command.

Variable

Value

<acl-id>

Specifies the ACL ID. Use the CLI Help to see the available range for the switch.

<0–15999999>

Specifies the I-SID associated with the customer VLAN (Layer 2 VSN) or the customer VRF (Layer 3 VSN). This I-SID must already be configured on the fabric node.

The InVSN Filter supports IP Shortcut traffic if the inVsn ACL match type is both. In this case, the I-SID is zero (0).

Important:

You can specify a Switched UNI I-SID if the I-SID is associated with a platform VLAN.
9037347-00 Rev AD