Configure a Segmented Management Instance

You must create a Management Instance to gain access to specific management applications.

About this task

The Management Instance supports different management interface types. When you create the Management Instance, you specify the interface type and the switch automatically creates the appropriate instance ID for that type.

In a Layer 2 routing deployment, use a management VLAN. In a Layer 3 routing or Fabric deployment, use a management CLIP. To separate management network from Layer 2 and Layer 3, use a management OOB.

Each Management Instance supports a IPv4 and IPv6 (global scope) management address for use by management applications.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Expand Mgmt Instance.
  3. Select Mgmt.
  4. Select the Interface tab.
  5. Select Insert.
  6. In the InstanceId field, select the type of Management Instance to create.
  7. Optional: For a CLIP Management Instance, in the VrfName field, type the VRF name to associate with the CLIP instance.
    Note

    Note

    If you want to associate the GRT with the CLIP instance, type GlobalRouter in the VrfName field.

  8. For a VLAN Management Instance, in the VlanId field, type the VLAN ID to associate the management VLAN with an existing port-based VLAN.
  9. For an OOB Management Instance, in the OOBIfindex field, select the interface port number to associate for Out-of-Band management.
  10. Select the State check box to enable the instance.
  11. To specify the interface as the default topology IP for LLDP advertisements, select InterfaceTopologyIpFlag.
  12. To administratively enable RMON for the interface, select RmonAdminEnable.
  13. For a DvR Leaf node, in the Isid field, type the I-SID value to associate with the Management Instance VLAN.
  14. Select Insert.

Interface Field Descriptions

Use the data in the following table to use the Interface tab.

Name

Description

InstanceId

Indicates the Management Instance type associated with this entry.

InterfaceType

Indicates the interface type.

VlanId

Specifies the VLAN ID to associate with the management VLAN.

OOBIfindex

Specifies the interface ID to associate with the management OOB.

VrfName

Specifies the VRF name to associate with the management CLIP .

State

Indicates if the interface is enabled for this instance. The default is disabled.

InterfaceMacAddr

Indicates the MAC address for the interface.

InterfaceName

Indicates the interface name.

InterfaceTopologyIpFlag

Specifies if the interface is the default topology source IP.

ZtpOn

Identifies the Zero Touch Provisioning status for the interface.

RmonAdminEnable

Specifies if RMON is administrative enabled for the interface.

RmonOperEnable

Indicates the RMON operational status for the interface.

RmonIpAddress

Indicates the RMON IP address for the interface.

MacOffset

Translates the IP address into a MAC address.

DropIcmpFragEnable

Enables IPv4 Fragmented ICMP packet filtering on the Management Instance. The default is disabled.

DropIcmpv6FragEnable

Enables IPv6 Fragmented ICMP packet filtering on the Management Instance. The default is disabled.

Isid

Specifies the I-SID number that associated with the Management Instance VLAN for the DvR Leaf node. For non DvR node, the default I-SID value is 0 and this value cannot be edited.