Configuring the MLD query maximum response time

About this task

Use this procedure to configure the query maximum response time for mld interface.

Enter Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the query maximum response time for mld interface:

ipv6 mld query-max-response-time <0–60>
Set the query maximum response time to its default value:

default ipv6 mld query-max-response-time

The following table describes the variables for the ipv6 mld query-max-response-time command.


Variable	Value
<0–60>	Indicates the query maximum response interval time in seconds.