Installing an RPS-500p in a Rack

To install the RPS-500p power supply in a 19-inch rack, you need the following:

Two rack-mounting brackets and mounting screws (rack-mounting kit) shipped with the power supply
Four customer-supplied screws to attach the power supply to a standard 19-inch rack

Caution

Observe all ESD precautions when handling sensitive electronic equipment.

Caution

Before rack-mounting the device, ensure that the rack can support it without compromising stability. Otherwise, personal injury and/or equipment damage can result.

To install the RPS-500p in a rack, follow these steps.

Attach the rack-mounting brackets to the RPS-500p using the eight M3x6mm flathead screws shipped with the power supply.

See Attaching the Rack-Mounting Brackets.

1 = Rack-mounting brackets (2)

2 = M3x6mm flathead screws (8)

With the rack-mounting brackets attached, position the RPS-500p between the vertical rack rails of the 19-inch rack as shown in Fastening the RPS-500p to the Rack.

1 = RPS-500p	3 = Mounting screws (4)
2 = Rails of 19-inch rack

Fasten the RPS-500p securely to the rack rails using four customer-supplied rack screws.
If you are installing the RPS-500p in a stacked configuration, repeat this procedure for each power supply.
Connect the RPS-500p to its power source.
See Connecting the RPS Cable and AC Power Cord to an RPS-500p.