Install a Versatile Interface Module in a 5520 Series Switch

This section describes how to install a versatile interface module (VIM) in the front slot of a 5520 Series switch.

You need the following tools and materials to install a VIM:

  • ESD-preventive wrist strap

  • Flat head screwdriver

Caution

Caution

Extreme Networks VIMs are not hot-swappable. Disconnect power to the switch before removing an installed VIM or installing a new VIM.

To install a versatile interface module, follow these steps:

  1. Attach the ESD wrist strap to your wrist and connect the metal end to an appropriate ground point on the rack.
  2. Ensure that the switch is completely powered down.
  3. Using two fingers, remove the cover plate from the VIM slot.
    1. Squeeze the sides to release the plate, and pull down from the top to open. The plate will remain attached at the bottom.
      Click to expand in new window
      Removing a slot Cover Plate (VIM slot cover shown)
      5520 VIM cover plate with pinch location arrows
  4. Remove the new VIM from its anti-static packaging.
  5. Install the VIM in the switch:
    1. Carefully slide the VIM module into the switch.
    2. Insert and tighten the retaining screws you previously removed, using the screws provided.
      Click to expand in new window
      Tighten Screws on the Inserted VIM Module
      5520 VIM screw locations with arrows and callout

      1 = VIM module retaining screw locations
121141-04 Rev. AB