Connecting the AC Power cord to the EPS-C2

Important

Important

When performing this task, observe all of the precautions listen in Safety Considerations for Installing Power Supplies.

After the redundant power cord is connected between the EPS-C2 and the switch, and an AC power cord to the internal power supply of the switch is attached to a power source, install the AC power cord to the power supplies in the EPS-C2 as follows:

  1. If necessary, slide the plastic cord retainer farther away from the back of the power supply.
    See Moving the Power Cord Retainer on the 750 W AC Power Supply.
    Click to expand in new window
    Moving the Power Cord Retainer on the 750 W AC Power Supply
  2. Connect the AC power cord to the input connector.
    Click to expand in new window
    Connecting the Power Cord on the 750 W AC Power Supply
  3. Open the clip and slip it over the barrel of the connector.
    Click to expand in new window
    Attaching the Power Cord Retainer on the 750 W AC Power Supply
  4. Snap the clip firmly around the connector.
  5. Connect the other end of the power cord to an AC power outlet.
    Warning

    Warning

    Always be sure that the source outlet is properly grounded before plugging the AC power cord into the AC power supply.
    Caution

    Caution

    Make sure that the AC power supply circuit is not overloaded. Use proper overcurrent protection, such as a circuit breaker, to prevent overcurrent conditions.
121141-04 Rev. AB