You configure a BGP peer as a
route-reflector client from the device that is the route reflector.
Procedure
-
Access global configuration
mode.
device# configure terminal
-
Access BGP configuration mode.
device(config)# router bgp
-
Specify the autonomous system in
which your device resides.
device(config-bgp-router)# local-as 1000
-
Access IPv6 address family
configuration mode.
device(config-bgp-router)# address-family ipv6 unicast
-
Specify the neighbor to be the
route-reflector client.
device(config-bgp-ipv6u)# neighbor 2001:db8:e0ff:783a::4 route-reflector-client
Example
The following example summarizes the commands in
this procedure.
device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 1000
device(config-bgp-router)# address-family ipv6 unicast
device(config-bgp-ipv6u)# neighbor 2001:db8:e0ff:783a::4 route-reflector-client
