show ipv6 ospf lsdb
Show the IPv6 OSPFv3 Link-state database configuration.
Syntax
-
show ipv6 ospf
lsdb
-
show ipv6 ospf lsdb [area
<A.B.C.D>] [lsa-type <0-7>] [lsid <0-4294967295>] [scope
<1-3>] [adv-rtr <A.B.C.D>] [vrf WORD<1-16>] [vrfids
WORD<0-512>] [detail]
-
show ipv6 ospf lsdb [vrf
WORD<1-16>] [vrfids WORD<0-512>]
-
show ipv6 ospf lsdb
adv-rtr {A.B.C.D}
-
show ipv6 ospf lsdb
adv-rtr {A.B.C.D} [vrf WORD<1-16>] [vrfids WORD<0-512>]
-
show ipv6 ospf lsdb area
{A.B.C.D}
-
show ipv6 ospf lsdb
detail
-
show ipv6 ospf lsdb detail
[vrf WORD<1-16>] [vrfids WORD<0-512>]
-
show ipv6 ospf lsdb
interface gigabitEthernet {slot/port[sub-port]}
-
show ipv6 ospf lsdb
interface vlan <1-4059>
-
show ipv6 ospf lsdb
lsa-type <1-11>
-
show ipv6 ospf lsdb lsid
<0-4294967295>
-
show ipv6 ospf lsdb scope
<1-3>
-
show ipv6 ospf lsdb tunnel
<1-2000>
-
show ipv6 ospf lsdb vrf
WORD<1-16>
-
show ipv6 ospf lsdb vrfids
WORD<0-512>
Command Parameters
- adv-rtr {A.B.C.D}
- Specifies the advertise router
configurations.
- area {A.B.C.D}
- Specifies the ipv6 lsdb area
configurations.
- gigabitEthernet {slot/port[sub-port]}
- Identifies a single slot and port.
If your platform supports channelization and the port is channelized, you must
also specify the sub-port in the format slot/port/sub-port.
- interface
- Specifies the ipv6 ospf lsdb
interface configurations.
- lsa-type <1-11>
- Specifies the ipv6 ospf lsdb
lsa-type.
- lsid <0-4294967295>
- Specifies the ospf lsdb
configuration for specific lsid.
- scope <1-3>
- Specifies the ipv6 ospf lsdb
scope.
- tunnel <1-2000>
- Specifies the ipv6 ospf lsdb
tunnel parameters.
- vlan <1-4059>
- Specifies the VLAN ID in the range
of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system
reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and
SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID 1.
- vrf <WORD 1-16>
- Specifies the VRF name.
- vrfids <WORD 0-512>
- Specifies VRF IDs.
