slpp-guard (for a port)

Syntax

• default slpp-guard

• default slpp-guard port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable

• default slpp-guard port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} timeout

• default slpp-guard timeout

• no slpp-guard

• no slpp-guard enable

• no slpp-guard port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable

• no slpp-guard port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} timeout

• no slpp-guard timeout

• slpp-guard enable

• slpp-guard port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable

• slpp-guard port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} timeout

• slpp-guard timeout <0 | 10–65535>

Command Parameters

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

enable

Enables SLPP Guard on a port. The default is disabled.

timeout <0 | 10–65535>

Specifies the time period, in seconds, for which {Conref}SLPP Guard disables the port. After the timeout period expires, the switch reenables the port. The timeout value can be 0 or a value ranging from 10 to 65535. With a value of 0, the port remains disabled until it is manually re-enabled. The default timeout value is 60 seconds.

Default

The default is disabled.

Command Mode

GigabitEthernet Interface Configuration