show ip rip interface
Display Routing Information Protocol (RIP) information for each interface.
Syntax
-
show ip rip interface
-
show ip rip interface
{A.B.C.D}
-
show ip rip interface
ports
-
show ip rip interface
ports {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
-
show ip rip interface
ports {slot/port[/sub-port][-slot/port[/sub-port]][,...]} [vlan <1-4059>]
[vrf WORD<1-16>] [vrfids WORD<0-512>] [{A.B.C.D}]
-
show ip rip interface vlan
-
show ip rip interface vlan
<1-4059>
-
show ip rip interface vrf
WORD<1-16>
-
show ip rip interface
vrfids WORD<0-512>
Command Parameters
- {A.B.C.D}
- Shows configurations based on an
IP address assigned to a VLAN.
- ports {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- vlan <1-4059>
- Shows RIP configuration
information for a particular VLAN. Specifies the VLAN ID in the range of 1 to
4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN
IDs 4060 to 4094 for internal use. If you enable VRF scaling and SPBM mode, the
system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you
cannot create or delete VLAN ID 1.
- vrf WORD<1-16>
- Specifies the VRF instance by
name. When applying a redistribution instance that redistributes from a nonzero
VRF to VRF 0 (the global router), do not specify the destination VRF; only specify
the source VRF.
- vrfids WORD<0-512>
- Specifies a range of VRF IDs.
