manual-area

Configure an Intermediate-System-to-Intermediate-System (IS-IS) manual area, 1-13 bytes in the format <xx.xxx.xxx…xxxx>. You must configure a manual area to use IS-IS. In this release, only one manual area is supported. Use the no format of this command to remove the area.

Syntax

manual-area xx.xxxx.xxxx...xxxx - 1...13 bytes
no manual-area xx.xxxx.xxxx...xxxx - 1...13 bytes

Command Parameters

xx.xxxx.xxxx...xxxx - 1...13 bytes: Configures the manual area in a size up to 13 octets. The current release supports one area. For Intermediate-System-to-Intermediate-System (IS-IS) to operate, you must configure at least one area.

Default

None

Command Mode

IS-IS Router Configuration

9036827-00 Rev AA