show ipv6 dhcp-relay
Display IPv6 Dynamic Host Configuration Protocol (DHCP) Relay information to show relay
information about DHCP routes and counters.
Syntax
-
show ipv6 dhcp-relay
counters
-
show ipv6 dhcp-relay
counters vrf WORD<1-16>
-
show ipv6 dhcp-relay
counters vrfids WORD<0-512>
-
show ipv6 dhcp-relay
fwd-path
-
show ipv6 dhcp-relay
fwd-path vrf WORD<1-16>
-
show ipv6 dhcp-relay
fwd-path vrfids WORD<0-512>
-
show ipv6 dhcp-relay
interface [gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}]
[vlan <1-4059>]
-
show ipv6 dhcp-relay
interface vrf WORD<1-16>
-
show ipv6 dhcp-relay
interface vrfids WORD<0-512>
Command Parameters
- counters
- Displays the count of DHCP Relay
requests and replies.
- fwd-path
- Displays information about DHCP
Relay forward paths.
- gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- vlan <1-4059>
- Specifies the VLAN ID in the range
of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system
reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and
SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID 1.
- vrf WORD<1-16>
- Specifies a VRF name. The VRF
parameter is optional.
- vrfids WORD<0-512>
- Specifies a VRF by ID. The VRF
parameter is optional.
