auto-negotiation-advertisements

Configure Auto-Negotiation advertisements after you enable Auto-Negotiation.

Note

Note

Because of port speed differences, not all parameters appear on all hardware platforms.

Syntax

Command Parameters

10-full
Advertises 10 Mbps full duplex.
10-half
Advertises 10 Mbps half duplex.
100-full
Advertises 100 Mbps full duplex.
100-half
Advertises 100 Mbps half duplex.
1000-full
Advertises 1000 Mbps full duplex.
10000-full
Advertises 10000 Mbps full duplex.
2500-full
Advertises 2.5 Gbps full duplex.
5000-full
Advertises 5 Gbps full duplex.
none
Configures the value to none.
port {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

None

Command Mode

GigabitEthernet Interface Configuration