show ipv6 nd interface
View neighbor discovery interface configuration.
Syntax
-
show ipv6 nd interface
gigabitEthernet [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]
-
show ipv6 nd interface
mgmtEthernet mgmt
-
show ipv6 nd interface
vlan [<1-4059>]
-
show ipv6 nd interface vrf
WORD<1-16>
-
show ipv6 nd interface
vrfids WORD<0-512>
Command Parameters
- gigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- mgmtEthernet mgmt
- Displays the neighbor discovery
management interface configuration.
- vlan <1-4059>
- Specifies the VLAN ID in the range
of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system
reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and
SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID 1.
- vrf WORD<1-16>
- Specifies a VRF name. The VRF
parameter is optional.
- vrfids WORD<0-512>
- Specifies a VRF by ID. The VRF
parameter is optional.
Usage Guidelines
The mgmtethernet mgmt parameter only applies to VSP 8600
Series.
