show ipv6 dcache

Display the destination cache to see next-hop addresses for destinations. The destination cache is only populated or updated when IPv6 packets originate locally on the central processor of the switch.

Syntax

show ipv6 dcache gigabitethernet {slot/port[sub-port]}
show ipv6 dcache mgmtethernet mgmt
show ipv6 dcache tunnel <1-2000>
show ipv6 dcache vlan <1-4059>
show ipv6 dcache vrf WORD<1-16>
show ipv6 dcache vrfids WORD<0-512>

Command Parameters

gigabitethernet {slot/port[sub-port]}: Identifies a single slot and port. If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
mgmtethernet mgmt: Identifies the management port.
tunnel <1-2000>: Specifies the tunnel ID.
vlan <1-4059>: Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
vrf WORD<1-16>: Specifies a VRF name. The VRF parameter is optional.
vrfids WORD<0-512>: Specifies a VRF by ID. The VRF parameter is optional.

Default

None

Command Mode

User EXEC

Usage Guidelines

The mgmtethernet mgmt parameter only applies to VSP 8600 Series.