show ip vrrp interface vlan
Show the extended Virtual Router Redundancy Protocol (VRRP) configuration for all VLANs on
the switch or for the specified VLAN.
Syntax
-
show ip vrrp interface
vlan
-
show ip vrrp interface
vlan <1-4059>
-
show ip vrrp interface
vlan {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
-
show ip vrrp interface
vlan verbose
Command Parameters
- {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- verbose
- Displays all available information
about the VRRP interface VLAN configurations.
- vlan <1-4059>
- Specifies the VLAN ID in the range
of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system
reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and
SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID 1.
- vrf WORD<1-16>
- Specifies the name of the
VRF.
- vrfids WORD<0-512>
- Specifies the ID of the VRF.
