show eapol status interface
Display the port Extensible Authentication Protocol (EAPoL) operation statistics for the
specified interface type.
Syntax
-
show eapol status
interface
-
show eapol status
interface gigabitEthernet
-
show eapol status interface vlan <1-4059>
-
show eapol status interface verbose
-
show eapol status
interface gigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
-
show eapol status interface gigabitEthernet
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} verbose
-
show eapol status interface vlan <1-4059> verbose
-
show eapol status
interface vlan <1-4059>
{slot/port[/sub-port][-slot/port[/sub-port]][,...]}
-
show eapol status interface vlan <1-4059>
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} verbose
Command Parameters
- gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- vlan <1-4059>
- Specifies the VLAN ID in the range
of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system
reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and
SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID 1.
- verbose
- Displays non-EAPoL client MAC information.
Usage Guidelines
The verbose
parameter is not supported on XA1400
Series or VSP 8600
Series