Drawing Boundary Walls

Draw the outside boundary of the building. The area within the boundary is used to determine device location and coverage. The area outside the boundary is ignored.

To draw boundary lines:

Go to Configure > Sites. Add a new site or select a site and select Floor Plans tab.
Select Draw Tools to display floor plan tools.
To anchor the beginning of the boundary line, click a corner of the outside boundary.
Click each corner to anchor the line. The drawing line zigzags across the image as you anchor each corner.

Note
If you make a mistake, you can click to edit the boundary or click to delete the boundary and start over.
When you finish the boundary, double-click the last corner to disable the pen tool.

Next, go to Drawing Inner Walls.