Access Points

Add and configure APs in ExtremeCloud IQ Controller from the Configure workbench.

Navigate to the Access Points list:
- To display all access points in your network, go to Configure > Devices. Add and configure APs from here.
- To display all access points associated with a specific site:
  1. Go to Configure > Sites.
  2. Select a site.
  3. Select the Access Points tab.
  Configure radio settings for access points that are associated with a specific site from here. To configure radio settings, select the appropriate Radio button.
To take action on one or more selected APs, select the Actions button.

The model and licensing domain of the AP determines the site configuration type and site licensing domain. The configuration Profile and RF Management for a device group are specific to the AP platform.

Use Auto Refresh to automatically refresh the information presented. From the Auto Refresh drop-down field, select the refresh value. Valid values are:

OFF
30 Seconds
1 Minute
3 Minutes
5 Minutes

You can also select

to manually refresh the page anytime.

Note

Save your page setting changes. Auto Refresh is implemented at the browser level and therefore will reset any selections or unsaved page setting changes. When using Auto Refresh, select a refresh interval that allows you to complete the operation within the defined interval. For best results, set Auto Refresh to OFF during configuration selections or selection of a large number of elements.

For more information about supported access points, see Access Points List.