| AP302W |
- Universal
AP with two operating modes: on premise and
cloud-enabled. For more information, see Universal AP Operational Modes.
- Radio
Modes:
- Mode 1 — Dual-band concurrent operation
- Mode 2 — Radio 1 dual-band sensor, Radio 2 5GHz
traffic forwarder
- Mode 3 — Radio 1 5GHz Low band, Radio 2 5GHz High
band traffic forwarder
- Ports on the Universal APs are labeled with the prefix ETH.
- ETH0 — 1GHz Uplink port (No LAG or Layer 2 backup
function support.)
- ETH1, ETH2, ETH3 — Local network client wired
ports.
- Pass-Through ports. Hardware wired ports, no
software support needed.
- PKI
support, IPsec tunnel security
- Client
Bridge is supported.
- Mesh
Network is supported.
- Internet
of things (IoT) devices are supported.
|
|
|
- Universal
AP with two operating modes: on premise and
cloud-enabled. For more information, see Universal AP Operational Modes.
- 2.4/5GHz
dual-band Sensor.
- Mode 1 — 2.4GHz service radio and 5GHz service
radio
- Mode 3 — 5GHz lower band service radio and 5GHz
upper band service radio
- AP305C/CX — IoT is supported.
- AP305C-1 — IoT is not supported.
- Client Bridge and Wired
Mesh Network extension are supported:
- When Client Bridge is configured on a single interface AP, the single
interface is used as the client port, not as an uplink, and you will not see the
GE2 Port Function field in the configuration Profile
Advanced Settings.
- When a single interface AP is configured as a Mesh non-root AP, the
single interface is used as a client port, not as an uplink.
- When a single interface AP is configured as a Mesh root, the
single interface is used as an uplink, not as a client port.
|
- AP310i/e
- AP310i/e-1
- AP360i/e
|
- One
dual-band 2.4GHz/5GHz radio and one 5GHz radio.
- Mode 1 — 2.4GHz service radio and 5GHz service
radio
- Mode 2 — 2.4/5GHz dual-band Sensor
and 5GHz service radio
- Mode 3 — 5GHz lower band service radio and 5GHz
upper band service radio
- AP310i/e and AP360i/e — IoT is
supported.
- The AP310i/e-1 — IoT is not supported.
|
