The selected Access List Mode applies to all access points in the site. The access
list is stored on the AP and shared across the site. A client MAC address on the
site Deny List, cannot connect to a network broadcast by any AP associated with the
site.
To set up an access list for clients associated with a site:
-
Go to and select a site.
-
Select Allow List/Deny
List tab.
-
Select Enforce site
level control over RF association.
-
Select the Mode: Allow List or
Deny
List.
-
To add MAC addresses to the
list, select Add and enter a MAC address for the client.
-
To delete a MAC address from the
list, select the MAC address from the list, then select Delete.
To select the entire list, select the MAC Address check
box.
