Test Result Details

Select a specific row to display the result details for that test run. Then, select a specific AP to view the results. The details that display depend on the configured test suite and test run parameters.

AP Service Test Result Details

• For each test, the number of times the test was run and the number of times the test passed is displayed.
• The following details for each test display:
  • Test Status
  • Start and End times for the test
  • Test command syntax
  • The following measurements: Tx, Rx, Loss, Round Trip (Minutes), Round Trip (Average), Round Trip (Max)
  • Errors
• Additionally, a wireless network test show the following details:

  Client Bridge Parent

  The serial number of the infrastructure AP in a Client Bridge deployment

  Network Name

  The name of the wireless network being tested

  SSID

  The Service Set Identifier of the wireless network being tested

  RSS

  Received Signal Strength. This value measures how well the selected AP can receive a signal.

  Noise

  Non-Wi-Fi interference measured in dBm

  Channel

  Radio channel for the selected AP

  Channel Utilization

  • BSSID. The MAC address of the radio interface that the client device is currently connected to. This is useful because each access point has a range of MAC addresses assigned to it.
  • SNR. Signal to Noise Ratio
  • Radio ID. Indicates the AP radio. Possible values are 1, 2, or 3.