Configuring Advanced RADIUS Servers Settings

  1. From the top menu, click VNS.
  2. In the left pane, click Global > Authentication.
  3. In the MAC Address area, click Advanced.
    Click to expand in new window
    Advanced RADIUS Server Settings
    Graphics/VNS_Radius_Adv_settings_upd.png
  4. Configure the following parameters:
    Click to expand in new window

    Advanced Radius Settings

    Field Description
    Include Service-Type attribute in Client Access Request messages Select if the client RADIUS Access Request message includes the "Service-Type" attribute. If included, the attribute is set to "Framed" by default.
    Set Service Type to Login If selected, the RADIUS "Service-Type" attribute of the client Access Request is set to "Login" (instead of "Framed").
    Note: RADIUS-based controller administrative access also sets the Service-Type attribute to "Login". Therefore, if you enable Service Type Login here, RADIUS-based administrative access is not allowed (and vice versa).
    Delay for Client Message for Topology Change Defines a delay during client authentication when switching from one topology to another. This is relevant for Captive Portal authentication. The delay gives time for the client to be assigned an IP address for the new topology before browser redirection. Set the delay in seconds.
    How should multiple RADIUS servers be used? Select an authentication option. The selection applies to all WLAN Services and to all sites on the EWC.
    • Round-Robin. The server is selected on a round-robin basis starting at the top of the list of approved servers. The first server is used until it fails, and that pattern continues down the list. When the last server fails, then the first server is used again.
    • Primary-Backup. Select a primary failover server to have control over which server provides redundancy. When you select Primary-Backup, the RADIUS server assigned to the site or WLAN Service is the primary for the WLAN Service. All other RADIUS servers assigned to WLAN Service are backups for the primary and continue to be selected in a round-robin approach. For controllers in an availability pair, the Primary and Backup servers must be synchronized (enable "Synchronize System Configuration" in Availability setup) if the WLAN Services are synchronized. If the primary server has failed resulting in a backup server being used for authentication, the controller will periodically send a "Health Check" to the primary server to see if it has recovered. If the primary server has recovered, the controller starts using the primary server for all new authentications. All authentications in progress continue to use the backup server. This feature impacts client authentication (not RADIUS Accounting) in the configuration where multiple RADIUS servers are used for authentication of primary server with backup servers.
    Use MAC-Based Authentication MAC address format for user authentication and accounting via RADIUS Allows the administrator to override the default MAC address colon-separated format (for example 00:11:22:33:44:55) with the Global Authentication MAC Address format for the following attributes:
    • Calling-Station-Id attribute of the RADIUS packet
    • Called-Station-Id attribute (if Called-Station-Id is not overridden by Zone name)
    • AP BSSID Mac in one of the vendor attributes
    • User-Name attribute.
    Note: This setting is enabled for new deployments. You must manually enable this setting for upgraded deployments.
    Radius Accounting Enabling RADIUS accounting activates RADIUS accounting only in WLAN Services specifically configured to perform it. Disabling RADIUS accounting overrides the RADIUS accounting settings of individual WLAN Services.
    Defer sending the accounting start request until the client's IP address is known Specify Authentication Behavior of RADIUS servers on Server Failure. If selected, the client RADIUS Accounting Request "start" command is not sent to the RADIUS server until the client IP address is known. By default, this option is not selected and the "start" command is sent once the client is authenticated.
  5. Click Close to close the Advanced Settings dialog.
  6. Click Save to save your changes.