Configuring Wireless AP LED Behavior

You can configure the behavior of the LEDs so that they provide the following information:

Click to expand in new window

LED Operational Modes

LED Mode Information Displayed
Off Displays fault patterns only. LEDs do not light when the AP is fault free and the discovery is complete.
Normal Identifies the AP status during the registration process during power on and boot process.
Identify All LEDs blink simultaneously approximately two to four times every second.

You can configure the AP LED mode when you configure the following:

  • An individual AP.
  • Multiple APs simultaneously.
  • Default AP behavior.
    Note

    Note

    You can configure all four AP LED modes if you configure an individual AP or multiple APs simultaneously. If you configure the default AP behavior, the only LED modes available are Off and Normal.