Basic Installation Wizard - Management Screen
The Management screen displays:
-
In the AP Password section,
enter a password for the AP. Click Unmask to display the password characters as you type. Access
Points are shipped with default passwords. You must create a new SSH Access
Password here.
![Note](../../images/Note_Note.png)
Note
Passwords can include the following characters: A-Z a-z 0-9
~!@#$%^&*()_+|-=\{}[];<>?,. Password cannot include the following characters: / ` ' "
: or a space.
-
In the Management Port section,
confirm the port configuration values that were defined when the controller was
physically deployed on the network. If applicable, edit these values:
- Static IP Address —
Displays the IPv4 address for the controller‘s management port. Revise this
as appropriate for the enterprise network.
- Netmask — Displays the
appropriate subnet mask for the IP address to separate the network portion
from the host portion of the address.
- Gateway — Displays the
default gateway of the network.
- Static IPv6 Address —
Displays the IPv6 address for the controller‘s management port. Revise this
as appropriate for the enterprise network.
- Prefix Length — Length of
the IPv6 prefix. Maximum is 64 bits.
- Gateway — Displays the
default gateway of the network.
-
In the SNMP section, click
V2c or V3 in the Mode drop-down list to enable
SNMP, if applicable.
If you
selected V2c, the Community options display:
-
In the OSPF section, select the
Enable checkbox to enable
OSPF, if applicable. Use OSPF to allow the controller to participate in dynamic
route selection. OSPF is a protocol designed for medium and large IP networks
with the ability to segment routes into different areas by routing information
summarization and propagation.
- Area ID — Type the
desired area. Area 0.0.0.0 is the main area in OSPF.
-
In the Syslog Server section, select
the Enable checkbox to enable the
syslog protocol for the controller, if applicable. Syslog is a protocol used for
the transmission of event notification messages across networks.
In the
IP
Address box, type the IP address of the syslog server.
![Note](../../images/Note_Note.png)
Note
The Syslog Server IP Address field supports both IPv4
and IPv6 addresses.
-
Click Next. The Services screen displays.