Install a 300 W Internal DC Power Supply

Caution

Caution

Make sure that the DC power supply circuit is not overloaded. Use proper overcurrent protection, such as a circuit breaker, to prevent overcurrent conditions. You may use up to a 30-Amp breaker.

To install a 300 W DC power supply (part no. 10933 or 10944) in a switch, perform the following tasks in the order listed:

  1. Make sure you have the tools and materials you need.
  2. Prepare the power cables and ground cable by attaching the provided connection lugs to the cables.
  3. Insert the power supply into the switch.
  4. Connect the ground wire.
  5. Connect the power supply to the DC source voltage.
  6. Energize the DC circuit.