Installing an RPS-150XT Redundant Power Supply

You can install the RPS-150XT power supply on a flat surface or in a 19-inch rack in the three-slot modular shelf (STK-RPS-1005CH3), which is available for purchase separately.

Caution

Caution

Observe all ESD precautions when handling sensitive electronic equipment.

Only qualified personnel should install redundant power supply (RPS) units.

Unpacking the RPS-150XT

To prevent electrostatic damage, attach an electrostatic discharge (ESD) wrist strap to your wrist before handling the RPS-150XT.

Unpack the power supply as follows:

  1. Remove the packing material protecting the power supply.
  2. Perform a visual inspection of the power supply for any signs of physical damage. Contact Extreme Networks if there are any signs of damage.

Installation Requirements

The installation site must be within reach of the network cabling and meet the following requirements:

A Phillips screwdriver and four rack screws (not supplied) are needed to install the RPS-150XT in a rack using the three-slot modular shelf.