Installing an STK-RPS-1005PS Redundant Power Supply

You can install the STK-RPS-1005PS power supply on a flat surface or in a 19-inch rack in the three-slot modular shelf (STK-RPS-1005CH3), which is available for purchase separately.

Caution

Caution

Observe all ESD precautions when handling sensitive electronic equipment.

Locate the STK-RPS-1005PS within 6 ft (1.8 m) of its power source.

Only qualified personnel should install redundant power supply (RPS) units.

Installation Requirements

A Phillips screwdriver and four rack screws (not supplied) are needed to install the STK-RPS-1005PS in a rack using the three-slot modular shelf.