You need the following tools and materials to install a V400 Virtual Port
Extender:
- ESD-preventive wrist strap
- #1 Phillips screwdriver (for
clock module) or flat-bladed screwdriver (for all other VIM modules)
Your V400 Virtual Port Extender comes with two mounting brackets and screws for
attaching them. Mount the equipment in a standard equipment rack, in either a front
or mid-mount configuration, in the same way you would mount a switch.
To install a V400 Virtual Port Extender, follow these steps:
-
Attach the mounting brackets to
the sides of the port extender using four screws (included) for each
bracket.
-
Align the holes in the brackets
with the rack post holes.
-
Secure the port extender to each
post with rack-mounting screws (not provided).
-
Connect an AC power cord to the
AC power input socket on the port extender and to an AC power outlet.
-
When power is connected, verify
that the SYS LED on the port extender turns green.
If the SYS LED does not turn
green, verify that the power source is powered on and the connection was made
properly.