Refer to Installing a Half-Duplex to Full-Duplex Converter for installation options for the Half-Duplex to Full-Duplex
Converter.
To mount a Half-Duplex to Full-Duplex Converter unit on a wall, follow these
steps:
-
Drill two holes in the wall,
each 4 mm (0.16 in.) in diameter.
The holes should be 10.5 cm (4.13 in.) apart so that they correspond to the
locations of the holes in the bottom of the converter.
-
Insert an anchor bolt (not
provided) into each hole in the wall.
-
Place a screw (not provided)
into each anchor bolt and tighten so that the screw head protrudes slightly from
the wall.
-
Place the converter onto the
screws and gently lower it so that it locks into place.
-
Connect the converter to its
power adapter, following the instructions in Connecting a Half-Duplex to Full-Duplex Converter to its Power Adapter.
-
Connect the full-duplex ports
(FD1 - FD4) to the switch.
-
Connect the half-duplex ports
(HD1 - HD4) to your half-duplex devices.